Proton Pack Hardware
This is the Hardware that is believed to be used on the Proton Pack. There are different variations for particular fastener types on each of the packs (GB1 & GB2: Hero, SemiHero, SuperHero, and Stunt). This is a generalized list. The lengths of the fasteners are unknown, however the lengths provided below are suggestions.
The following list is a generalized list for the GB1 Proton Pack:
Thrower:
6-32 socket cap head screws:
Instrument bar
Barrel lock
Bottom plate
Front gun ear
Gun knub under the brass washers
6-32 flat hex head screws:
Female V-Hook on Thrower Bracket/Gun Track
8-32 socket cap head screws:
Thrower Bracket/Gun Track
Screw between the side adjustment knobs
Washer to hold down S-Hook
(Also correct for the bottom plate)
4-40 socket cap head screw:
Top knob
Fasteners needed for Thrower:
Larger side knobs
Smaller knob that attaches to larger side knob
Front thrower knob
Heat sink from inside of Thrower
Larger side knob by Heat sink
Thrower Bracket/Gun Track Disks
Proton Pack:
4-40 socket cap heads:
2 x 3/8" long for resistors on the Ion Arm.
8-32 socket cap heads:
2 X 1" long for Booster frame (on some packs)
Screw beneath the Ribbon Cable hole ( Spengler pack )
2 screws X 1" long through the Ribbon Cable Clamp
2 screws through the Clippard valve
10-32 socket cap heads:
2 X 1" long Booster frame (on some packs)
Ion Arm
1/4-20 socket cap head:
4 x 1/4"-1/2" on the HGA
4 x 1 1/2"+ attaching the bumper (1/4 pan head Phillips on GB2 packs)
4 x 1 1/4"+ for attaching the shell to the mobo (1/4 pan head Phillips on GB2 packs)
8-32 slotted flat head machine screws:
2 for V-hook Male bracket mounted from inside.
==References==