By GBDRE760
#4922696
To anyone who has ever did a build with the light kit from the shop here, how did you mount the light kit? I am testing a few options. I am also building a mount that can be 3D printed but I am also wondering how I should mount the little rumble motor as well. Any ideas?
#4922705
The board is designed to fit on the lower side wall opposite the two gun-discs. I used the screws from the gundiscs to mount a piece of plastic on the interior wall, and then mounted the board to that.

And I'm fond of the idea of putting the motor inside the front cylinder, if possible.
GBDRE760 liked this
#4922707
Prologic9 wrote: August 18th, 2019, 1:16 pm The board is designed to fit on the lower side wall opposite the two gun-discs. I used the screws from the gundiscs to mount a piece of plastic on the interior wall, and then mounted the board to that.

And I'm fond of the idea of putting the motor inside the front cylinder, if possible.
Oh wow! I love that idea. I am waiting for my knobs to get here but I am sure I can design some kind of 3D printed bracket that can mount on the knob screws. Putting the motor in the front cylinder....... sounds like an awesome little hideaway spot for that! Unfortunately I have 3D printed my front cylinder pretty much solid but I can make a hallow version if I have to. Thanks for the ideas :)
    Matty PKE Question...URGENT

    Depending on the price, it might be worth snatchin[…]

    I have a full sized spirit pack, and I have the gh[…]

    If you need any clarification at all, PM me or […]

    Proton Props UK

    Good decision to lift the ban! By the way: I think[…]