Aaaaaand got my response...
I have been told that we have no future plans of designing trays for Ghostbusters: The Board Game 2, however, this may change depending on the number of requests that we receive. We will announce any new releases of trans on Battlefoam’s Facebook page.
If you would like to have custom foam made for your stuff, consider looking into tracing and designing the trays yourself. We can cut any designs that are sent to us.
Here are some step by step instructions that we hope will get you started:
1) Print out a custom order form and make sure to complete all sections:
http://www.battlefoam.com/BattleFoamCustomForm.pdf 2) Gather the models
3) Place the models on the Custom Trace Sheet that has a ruler. All pages with tracings must have a ruler on the side. This helps to ensure that any resizing due to printers, faxes, or programs can be properly corrected once we receive them.
4) Carefully start tracing the models as close to the edge as possible with a pencil or pen. Keep a close eye that the models do not move or shift during tracing. When finished remove the model and retrace the shape with a marker such as a Sharpie. For visual reference please see our examples at
http://us.battlefoam.com/pages/Custom-Order-Form.html.
5) Label. Please be as detailed with your description as possible
6) Write your first name, last name, phone number, email address, and order number (if you have it) on the Custom Trace Sheet
7)
http://us.battlefoam.com/categories/Cus ... oam-Trays/ -- Use this link to purchase your desired size tray.
NOTES
-Our Design Team works in Inches
-The ruler on the side of the paper is only for scaling purposes. It is there in case the image is resized by printers or programs. It is not intended to be a layout for the tray
-Our Design Team creates the layouts based upon the shapes, unless specific layout instructions are sent
-If the models is bigger than the page you can simply tape two pages together and trace, detach and scan, the Design Team will align them
Kind Regards,