Page 1 of 1

3d printed belt gizmo with light and daughter board

Posted: July 12th, 2020, 9:59 am
by q.kiou
This is my version of the belt gizmo, the trick was to make it without any paint.
Every colors is a different part and for the leds I used a modified led rope from the dollar store.

Image
Image
Image
Image
Image
Image

Re: 3d printed belt gizmo with light and daughter board

Posted: July 13th, 2020, 9:44 am
by cristovalc
Great work! This is one of the cleanest 3D printed gizmo's I've seen!

Re: 3d printed belt gizmo with light and daughter board

Posted: July 13th, 2020, 5:05 pm
by robandliv
Did you add all the lines? It looks great.

Re: 3d printed belt gizmo with light and daughter board

Posted: July 16th, 2020, 12:14 pm
by q.kiou
thank you! All the line are molded and printed. I simply switched filament to gold.
There is no paint required.

Re: 3d printed belt gizmo with light and daughter board

Posted: August 1st, 2020, 2:53 pm
by q.kiou
Completed project with the holster
I will need to add velcro on the back to hold the gizmo in place.
Battery pack is screwed on the back.

Image

I now working on a Gb1/GB2 mashup gizmo, basically the same one with the color of the second film.

Image