By davidkram2003
#4895296
Hey everyone, I'm building a giga meter on my 3D printer and I have just about everything printed but I can't figure out a way to add the clear dome. What has everyone used for the done and where to get it. Thank you
User avatar
By Tyrael
#4895358
I'm assuming you printed the files I posted up on the Thingiverse? If so, I used the same domes AZSpidey did in his Gigameter build. They can be found here: https://kitkraft.com/products/3-1-2-88-9mm-clear-domes

By the way, I'd hold off on finalizing any build just yet. I'm redoing a few of the files to be easier to build the whole thing.
Cole Funstuff liked this
By davidkram2003
#4895359
Thank you for the info. I already finished printing everything and assembled it and just needed the dome to finish it. The only part I had trouble printing from those files was the microphone ears but other than that everything else came out great. Thank you for making those files available for everyone.
Tyrael liked this

    The_Y33TER , since the majority of the maker scen[…]

    Thanks The_Y33TER ! Confirmation there's no elect[…]

    A little sneak preview of one of the bedrock parts[…]

    Where do the other ends of the red/yellow wire[…]