User avatar
By trekgod3
#4944417
Hey all, here's another 3d printed pedal build. I'm using a mixture of FDM and resin printed parts from my Ender 3 and Photon Mono. I originally printed the vector plate in resin but it cracked when I drilled a hole in it , so I reprinted in PLA . I used Siraya tech abs like resin which is pretty tough but it still cracked. Oh well. I am waiting on an 8 pin octal relay ($7) and an IDE ribbon cable ($5) both coming from Ebay next week to finish it up. I am using an old phone charging cable cut to length and painted red and yellow to simulate the tubing , and I know the paint and hardware aren't screen accurate, but it's been a fun project. I didn't bother with the bellows under the pedal because I plan on stuffing the existing walmart pedal under it to activate the trap.

Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image

Repainted Wal-Mart trap:

Image
Image
Image
Image
Image
Image
    Matty PKE Question...URGENT

    Depending on the price, it might be worth snatchin[…]

    I have a full sized spirit pack, and I have the gh[…]

    If you need any clarification at all, PM me or […]

    Proton Props UK

    Good decision to lift the ban! By the way: I think[…]