[berk]

It's been a while since I posted and the 3d parts I published almost 6 years ago (!!) are still quite popular. I'm about to embark on an improvement drive of the parts ( I know others have already started this!) and I'm looking for suggestions. If anyone has any comments please post below and I'll try and integrate them when I can. Any implemented mods will be credited!

What I have so far are:

Increase the facet count of circular parts.
Integrate the gun track into the thrower properly.
Improve the mounting of the cyclotron to the sync generator (i.e. do it so it actually works!)
Add wiring channels to make fitting the electronics easier.
Write a manual.


thanks for your help!

Tony

[slinkbe]

Glad to see you come back to your files !
They showed me it was possible and inspired me to do my own.
We have a small but growing community of proton pack 3D printer enthusiast. please, come visit us
https://www.facebook.com/groups/3DprintedGBprops/