- August 16th, 2018, 7:25 am#4907668
Hey everyone,
I am currently putting together a "throwing chicken Neutrino Wand kit. I'm still early on in the process but I am struggling with how to install the light and button on the front of the barrel.
The piece where the light and button go is solid and it doesn't appear there is a way to drill or open it up from the inside.
Just wanted to get some feedback as to how others have done it to find the best way.
I was thinking of hollowing it out from the bottom and cutting a piece of kydex plastic to make a base plate and glue it on once installed. problem would be there would now be a base plate which I don't believe would look right.
I am currently putting together a "throwing chicken Neutrino Wand kit. I'm still early on in the process but I am struggling with how to install the light and button on the front of the barrel.
The piece where the light and button go is solid and it doesn't appear there is a way to drill or open it up from the inside.
Just wanted to get some feedback as to how others have done it to find the best way.
I was thinking of hollowing it out from the bottom and cutting a piece of kydex plastic to make a base plate and glue it on once installed. problem would be there would now be a base plate which I don't believe would look right.