This is for other Ghostbusters Props that don't fit into the categories above.
#4895271
So, for my outfit, I decided I wanted Ray's GB1 radio, the Motorola HT200.

Problem is, much like the MT500, finding holsters for them is quite hard.

So I grabbed a NTN8038B holster, which is for the HT1000, a significantly shorter radio. Then I cut the bottom out.

Image

From there, the radio fell through the holster, so I designed a 3D printed backplate to install in the holster that keys into the antenna molding in the rear of the radio. This was printed in PETG for abrasion resistance (so we don't mar the radio!)

Image

Now, I just needed to cap it off. I printed up a cap in soft TPE, complete with Motorola logo. This also lets the radio stand upright on a surface!

Image

All files available here on Thingverse: https://www.thingiverse.com/thing:2417771

I'm currently printing a larger version for the large 3-Knob MT500 radios using the NTN8036B holster.

    Yeah, we've been building this thing for ten[…]

    Someone on FB found it. NARDA ELECTROMAGNETIC RADI[…]

    It appears that some time today someone who […]

    Correct, it grants several in fact the Melody's […]