Heat Sinks for Pump Boxes

Heat Sinks for Pump Boxes#4803683

By goldenhawk - August 2nd, 2014, 7:07 am

- August 2nd, 2014, 7:07 am#4803683

Has anyone made a resin cast or figured out where to get the heat sinks for the pump boxes? I need them to finish my Slime Blower.

Thanks.

AJ said I am an elitist. Damn straight I am. I didn't climb the corporate ladder to be mediocre.

Ghostbusters......is.....dead.

Re: Heat Sinks for Pump Boxes#4803688

By Kingpin - August 2nd, 2014, 8:21 am

- August 2nd, 2014, 8:21 am#4803688

The real heat sink has not yet been identified. I think Nickatron did offer a limited run of resin heat sinks, but he doesn't appear to be producing them at the moment.

Feeling overwhelmed by the Covid-19 pandemic? Please visit The Support Thread.

What would Ryan do?

Re: Heat Sinks for Pump Boxes#4809633

By goldenhawk - September 15th, 2014, 6:27 pm

- September 15th, 2014, 6:27 pm#4809633

This post may contain an affiliate link that helps support GBFans.com when you make a purchase at no additional cost to you.

Found them on ebay:
http://www.ebay.com/itm/171321400212?_t ... EBIDX%3AIT

I bought four. Two for each pump box.

AJ said I am an elitist. Damn straight I am. I didn't climb the corporate ladder to be mediocre.

Ghostbusters......is.....dead.

Re: Heat Sinks for Pump Boxes#4816489

By Wildcard - October 27th, 2014, 12:51 pm

- October 27th, 2014, 12:51 pm#4816489

It is possible to print...

Re: Heat Sinks for Pump Boxes#4817057

By Turbomini73 - October 31st, 2014, 11:51 pm

- October 31st, 2014, 11:51 pm#4817057

That printed one is fantastic are you willing to share the file?

Re: Heat Sinks for Pump Boxes#4817461

By Wildcard - November 3rd, 2014, 8:17 pm

- November 3rd, 2014, 8:17 pm#4817461

At the current time, no. Sorry!

I'm planning on selling parts once I hit 50 posts here

Re: Heat Sinks for Pump Boxes#4817720

By Wildcard - November 5th, 2014, 12:27 pm

- November 5th, 2014, 12:27 pm#4817720

Btw, while i haven't gotten a new crucible yet, I have thought about how to use a print to make and aluminum casting. Something that will probably take a while, but in the realm of possibility