[davidkram2003]

Hey everyone, I'm building a giga meter on my 3D printer and I have just about everything printed but I can't figure out a way to add the clear dome. What has everyone used for the done and where to get it. Thank you

[Tyrael]

I'm assuming you printed the files I posted up on the Thingiverse? If so, I used the same domes AZSpidey did in his Gigameter build. They can be found here: https://kitkraft.com/products/3-1-2-88-9mm-clear-domes

By the way, I'd hold off on finalizing any build just yet. I'm redoing a few of the files to be easier to build the whole thing.

[davidkram2003]

Thank you for the info. I already finished printing everything and assembled it and just needed the dome to finish it. The only part I had trouble printing from those files was the microphone ears but other than that everything else came out great. Thank you for making those files available for everyone.