- October 9th, 2018, 2:30 pm#4909763
I give you full permission to call me names, but is the plate that goes on top over the "bargraph lights" in the print files? I went to print and don't see that.
- October 9th, 2018, 2:43 pm#4909765
I'm noticing that no one has changed out the red rods on the side. They look a lot thinner than they should be to me. Or am I wrong?
- October 9th, 2018, 6:13 pm#4909768
The red rods that come on the SH Trap are about 0.4", so yes, about a tenth of an inch smaller than what I've seen on plans.
Personally, it doesn't bother me enough to change them out, but I could see how that might bother some people. Not a difficult fix, really.
Personally, it doesn't bother me enough to change them out, but I could see how that might bother some people. Not a difficult fix, really.
- October 24th, 2018, 6:52 pm#4910230
randomZERO wrote: ↑October 10th, 2018, 5:27 pm Nevermind I figured out what I needed. Thanks again.Im so sorry. I just stopped getting emails and didnt know I had posts here.
GBFANS Ghostlabs light kit
- By prodestrianWhen you say you only have the proton pack light k[…]
Pchrisbosh1 GB1 Hero Shell 3D Model for 3D Printing! Updated 4/23/04
- By prodestrianI'm not familiar with this one (is it a model?) […]
Frozen Empire GB Jumpsuit (Khaki)
- By Hairy BikerAlso somewhat related question...I don't see giz[…]
Ghostbusters Day 2024
- By tylergfosterEven if Frozen Empire somehow made a billion dol[…]