- October 17th, 2017, 3:10 pm#4899809
Hey guys, I am in the middle of making a ghost trap to go with my proton pack this Halloween and I recall on a trap that I made a long time ago that there was barely any room to get a bar graph into the front of the cartridge because I used 1/4" plywood to assemble the LED housing of the Ghost Trap Cartridge. Now it is time for me to work on that part and I am hoping I can get it right this time. I really wish there was some place near me that I could pick up some styrene. I really hate to have to order stuff unless it's from here, lol. So considering the fact that there is no styrene nearby and you made the rest of the trap out of 1/4" plywood, what would you make the front of the cartridge out of if you were making this trap? Also, I really do dig the way the hinge was on the Matty trap. Would there be a way for me to do something similar to that with this trap? I am using the Venkman 71 plans with a few slight modifications. Thanks guys.