[SpookyDaveG.]

I have a technical question for owners of the GBFans Soundboard.

I have a Spirit Pack that I am planning on using but I changed out my Neutrona Wand for an RGB one. It already has the screen accurate switches installed on it and all I have to do is wire it up. Is there a way to run wires from the RGB Wand directly to the GBFans soundboard (allowing me to keep the existing switches) or would I have to purchase the GBFans Wand Light and Switches Kit and then modify it to allow for me to use the RGB switches?

The board looks like I could just attach a wire then screw it down but I don't know for sure.

[hybridflux]

So I'm not entirely familiar with the RGB wands BUT I do know that the GBFans Soundboard works on a "grounded switch" setup. IE, if your wand also uses a common ground from the pack you can then piggy back off the switches. May not be pretty, but it would/should work.

[SpookyDaveG.]

Sounds like a plan! Thanks!