- November 5th, 2018, 2:40 pm#4910478
This may have been talked about already. However, I was wondering if anyone has replaced the matty wand tip with a clear one. If so, does anyone have a "how to" guide?
ccv66 wrote: ↑November 5th, 2018, 5:19 pm Not sure replacing the whole milky tube is worth the risk. For all I know, the LEDs are glued to the tube. I did cut off the rubber tip with a pocket knife, added new trigger tip, banjos and glued a bevelled tip I cut off from an acrylic tube . To me, that was the biggest eye soar and easy to do. You don't see the tube on the pack untill you extend the barrelWow, got any pics?
ccv66 wrote: ↑November 5th, 2018, 5:19 pm Not sure replacing the whole milky tube is worth the risk. For all I know, the LEDs are glued to the tube. I did cut off the rubber tip with a pocket knife, added new trigger tip, banjos and glued a bevelled tip I cut off from an acrylic tube . To me, that was the biggest eye soar and easy to do. You don't see the tube on the pack untill you extend the barrelIf I replaced the white tube, I could also snip the wires to the light and just wire in the GBfans light (the board got ruined, but the wand tip light works).
Preview for #2 on DH's page. https://www.darkhors[…]
The_Y33TER , since the majority of the maker sc[…]