- September 29th, 2015, 5:59 pm#4844889
On one of my matty throwers the clippard is not flush with the body, i.e. One side there is a small gap. I could take some epoxy to it but pulling it it kind of clicks loose 1/16" so I figured I try to pull it off and reseat it, but no luck. Also the 507 on the matty wasn't that the same diameter as the 701/331 on the the real prop, just 1/4" shorter? Overall the matty is 1/2" longer than the hero GB2 wand I think so the correct clippard may look right on it. But taking the plastic one off isn't happening without some strip down pics
JoeLuna33 wrote:Whats a bung?gold333 wrote:I'm trying to find out if the whole plastic clippard is removeable on the matty wand... Does anyone know?You could probably get it off. I disassembled one of the throwers and I think it had a plastic bung that it slipped onto. It's smaller than a standard Clippard as well so a cast or real one would look over sized on it.
It feels like it might come off if pulled hard enough, but I figured I would ask here first so I don't bust it up.
On one of my matty throwers the clippard is not flush with the body, i.e. One side there is a small gap. I could take some epoxy to it but pulling it it kind of clicks loose 1/16" so I figured I try to pull it off and reseat it, but no luck. Also the 507 on the matty wasn't that the same diameter as the 701/331 on the the real prop, just 1/4" shorter? Overall the matty is 1/2" longer than the hero GB2 wand I think so the correct clippard may look right on it. But taking the plastic one off isn't happening without some strip down pics
TORN. I HATE WOMEN, BUT THOUGHT THE NEW GHOSTBUSTERS MOVIE WAS REALLY GOOD.