- August 24th, 2013, 1:10 pm#457024
No doubt many of you are disappointed with the inaccurate and unimaginative labels that Matty included with their Ecto Goggles. Here are some lens and body labels that I recreated for the use of the community.
I have included both black and olive drab versions of the battery and power knob labels; the green version is meant to simulate the clear stickers/dry-rub transfers used on the GB1 goggles. The military symbols normally seen on the thrower have been commonly thought to be on the right side of the frame.
There was little point in recreating the side label, since there are two definitive versions available to the community:
AN/PVS-5a Operating Instructions Label (HProps)
Redrawn Operating Instructions Label (Kingpin)*
*For those who may not have noticed, Matty "borrowed" Ben's drawing (albeit with a few alterations) for use on their product.
I have included both black and olive drab versions of the battery and power knob labels; the green version is meant to simulate the clear stickers/dry-rub transfers used on the GB1 goggles. The military symbols normally seen on the thrower have been commonly thought to be on the right side of the frame.
There was little point in recreating the side label, since there are two definitive versions available to the community:
AN/PVS-5a Operating Instructions Label (HProps)
Redrawn Operating Instructions Label (Kingpin)*
*For those who may not have noticed, Matty "borrowed" Ben's drawing (albeit with a few alterations) for use on their product.